Ultra Mag Powders and Barrel Life

MontanaRifleman

Well-Known Member
Joined
May 21, 2008
Messages
6,186
Location
South of Canada and North of Wyoming
I dug up an old (4 yrs) thread on this subject and wondered if anyone might have some experience or anything to add.

http://www.longrangehunting.com/forums/f19/barrel-wear-7mmrum-10472/

In the article, Kirby says he believes the large overbores can get improved barrel life by switching from the stick powders to the newer ball powders which he believes are fairly temp stable and will burn "clean" at higher pressures. These include Ramshot Magnum and AA8700. He says these powders dont burn as "hot" as the stick powders.

Kirby, sorry to take your name in vain, :) but I find this a fascinating subject, especially scince I have a 300 RUM and am considering a 7.

Anyway, was wondering if anyone else has any experience and insight with this that they could share on the subject. Any one using these powders in their Ultra's?

Mark
 
I spoke with the folks at sierra asking about data for the 6-284 and they said that was the case.
 
I had read recently that US869 was an "extremely cool burning" powder but can not for the life of me remember the source so take it with a grain of salt. It certainly makes sense to me that if two powders shot the same number of rounds in the same amount of time and the barrel was cooler with one vs the other the barrels life would likely be affected adversely by the hotter powder. That is something you could easily verify yourself at the range.
 
I had a 300 rum with a 30" barrel and put 2500 rounds through it (still good) I shot primarily H870 which is no longer available from Hodgedon. This powder would produce 100 fps more velocity than ANYTHING else! You can still get T870 from Thunderbird Cartridge in Az. It is identical to the old H870 (military surplus) and I would highly recommend it.......Richlightbulb
 
I have more rounds than I should have through a 270 AM barrel. Most w/US 869 couple of 100 w/7828ssc.

Barrel is in "much" better shape than one would expect according to a "local" smith who says he "knows" things about barrels??????:rolleyes:
 
I dug up an old (4 yrs) thread on this subject and wondered if anyone might have some experience or anything to add.

http://www.longrangehunting.com/forums/f19/barrel-wear-7mmrum-10472/

In the article, Kirby says he believes the large overbores can get improved barrel life by switching from the stick powders to the newer ball powders which he believes are fairly temp stable and will burn "clean" at higher pressures. These include Ramshot Magnum and AA8700. He says these powders dont burn as "hot" as the stick powders.

Kirby, sorry to take your name in vain, :) but I find this a fascinating subject, especially scince I have a 300 RUM and am considering a 7.

Anyway, was wondering if anyone else has any experience and insight with this that they could share on the subject. Any one using these powders in their Ultra's?

Mark

Mark
The military did a lot of testing to determine what type of powder was best for long wear
and determined that the ball powder seamed to be less abrasive on the throat of barrels.

They felt that it was the shape instead of burn rate or temperature. The stick powders eroded
faster because of the sharp edges on the cylindrical powders.

They were also looking for a certain port pressure for there gas guns and the ball powder
was easier to predict at barrel lengths to the port.

As to the issue of cooler or less temperature sensitive , There are some ball powders that
are extremely temp sensitive. (One of my favorite powders ,H414 is one of those) but there
are some stick powders that are also heat/temp sensitive.

I feel that poor barrel maintenance has more to do with barrel ware that any other one thing.

Case capacity,velocity,barrel temperature, cleaning,type of powder, amount of fouling all
contribute to barrel ware. That is the reason the military tries to hold velocity to around
3000 ft/sec, use ball powders and know that the rifles cannot be cleaned every time they
are shot. And also temperatures will sometimes be high during a fire fight.

I have barrels that use stick powder that have over 20,000 rounds through them and accuracy
is still sub 1/2 MOA.

On the big Magnums I use a lot of H 50BMG (Stick) and H869 (Ball) depending on what the rifle
likes and don't worry about the barrel getting 20,000 rounds through it because they are
hunting rifles and with proper cleaning they should last a lifetime.

So enjoy the rifles and feed them what they like.

Just my 2 cents

J E CUSTOM
 
Don't know where I picked this up but here it is
barrelburnchart.jpg


Might convince a few to use faster powders :)
 
Don't know where I picked this up but here it is
barrelburnchart.jpg


Might convince a few to use faster powders :)

Just curious ,What is the source of this chart?

I have never had a barrel that was gone at only 400 rounds and I was wondering
How this data was compiled and by whom.

It may be computer generated and not real world results.

Just curious.

J E CUSTOM
 
I wish I knew J E. The downloading on my computer says I have had it since January of this year. I will do a search and see if I can find out.
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top