MagnumManiac
Well-Known Member
- Joined
- Feb 25, 2008
- Messages
- 5,568
G'day all,
Had an accident in my loading room on the weekend, I am fine, but half of my reloading gear has been irreparably damaged and not sure what to do.
My entire shelf with my digital scale, case trimmer, beam scale and 2 powder measures toppled over while I was drilling new holes for my CPS unit, as the primer tube was interfering with my ability to reach the light switch.
Anyway, the hoppers have broken, the lid of the digital scale has broken and the beam scale is bent and probably will never be in calibration again, and the case trimmer has a bent handle and the case holder housing is broken where it screws in place. I don't know if the internals of my digital scale are OK or not at this stage.
Way too much money for me to replace all this gear in one hit.
Which would you replace first?
Cheers.
Had an accident in my loading room on the weekend, I am fine, but half of my reloading gear has been irreparably damaged and not sure what to do.
My entire shelf with my digital scale, case trimmer, beam scale and 2 powder measures toppled over while I was drilling new holes for my CPS unit, as the primer tube was interfering with my ability to reach the light switch.
Anyway, the hoppers have broken, the lid of the digital scale has broken and the beam scale is bent and probably will never be in calibration again, and the case trimmer has a bent handle and the case holder housing is broken where it screws in place. I don't know if the internals of my digital scale are OK or not at this stage.
Way too much money for me to replace all this gear in one hit.
Which would you replace first?
Cheers.