• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Berger bullets question?

Scratch

Well-Known Member
Joined
Jan 26, 2012
Messages
148
Location
Riverton, Wyoming
In the new Bergers reloading manual they give a OAL of 1.459" for their 210 grain (.308) VLD hunting bullet(P/N 30515). I went to trim the meplat just to square up the tip of the bullet but before that I measured the OAL and the measurement was .024" longer then 1.459".

My question is do I need to trim the bullets to achive the OAL of 1.459" or just square them all up to the same OAL"? If I trim off more then .005" (recommended) won't that mess up the BC and and the meplat!

Thanks in advance

Scratch
 
I personally don't do anything to the meplats of the 210's and have found my accuracy, drops, and ES to be very consistent. The manufacturing process results in a variation of the tips, effecting the OAL of these bullets. I pay more attention to the ogive length which is usually within .002" even with different lots of the Bergers.
 
Warning! This thread is more than 11 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top