gunsmith needed to attach handle to bolt.

[Timmyatneb]

Hi i was shooting yesterday. About my 5 shot i had a stuck case. I had a guy work up s loaf for me becaise i was having a hard tome getting gun to shoot accurately . This man settled on a load of 90 grains h 1000. . I was shooting 89.5 grains. Anyway the bolt would lift up but not go reareard. I lifted it up and taped on it with a cleaning rod no luck. A called a guy i trust he said wrap the handle and tap on it with a rubber mallet. I did and now i have a two piece bolt the handle came off. Does anyone know a gunsmith that can attach the handle back on with like it was
Need some advice
thank you.

 

[ultraedge]

Nathan Dagley at Straight Shot Gunsmithing. Excellent workmanship. Gary

 

[Timmyatneb]

Thank you ive figured out how iam gonna go now. Thanks again

 

[Hired Gun]

Another super experienced guy is Welcome to Accu-TIG

 

[Timmyatneb]

Thats good to know ill call them. Thank you.

 

[jsthntn247]

Don't go through the nightmare I am going through right now. Make sure you send the barreled action in and not the bolt only.

 

[Timmyatneb]

Why .whats the nightmare?

 

[ultraedge]

The action and the bolt need to be sent together in order to get the bolt timing correct. Gary

 

[jsthntn247]

The action and the bolt need to be sent together in order to get the bolt timing correct. Gary

^^^ This

 

[Timmyatneb]

Hope the accu tig guy can get it right. He said he could time it and didn't need action.

 

[tigguy]

Hope the accu tig guy can get it right. He said he could time it and didn't need action.

Any follow-up to this? How did it turn out, if AccuTig did the work?

 

[Timmyatneb]

It turned out good I haven't fired it yet . I need to have the bolt cericote again.

 

[sandbar782]

Should you fire it before you have re-cericoated to ensure everything works properly first?