• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

338 EDGE with RL 26 & 265 gr Cutting Edge MTH bullets

Swamplord

Well-Known Member
Joined
May 2, 2004
Messages
2,222
Location
Alaska
More load development with the 338 Edge, this time it's the 265 gr Cutting Edge MTH Max bullets with a .800 bc printed on box....... Alliants Reloder 26 powder... case prep was the same as last time from the same batch of 300 RUM Norma brass, new unfired just necked up.....
http://www.longrangehunting.com/forums/f19/chinchaga-338-cal-300-gr-338-edge-rl33-171543/

338 Edge 30" 9.5 tw Obermeyer barrel
COAL 4.070" CBTO 3.182" (.020" jump)
Reloder 26 powder in all loads, Fed 215 mag primers from late 1990's bricks I had stashed in ammo cans and forgot about, they still work ! my Y2K stash came in handy, hahaha !

87.0 gr 2839 fps
87.5 gr 2857
88.0 gr 2873
88.5 gr 2908
89.0 gr 2918
89.5 gr 2927
90.0 gr 2967
90.5 gr 2981
91.0 gr 2983
91.5 gr 3019
92.0 gr 3039
92.5 gr 3063
93.0 gr 3075 (node)
93.5 gr 3119
94.0 gr 3123 (faint signs of pressure, stopped shooting)

This is a single shot load due to the OAL of the loaded cartridge..
the 265 gr bullets were seated just off the case mouth and the Hornady OAL gauge with the #33 comparator shows .020" off the rifling but it's a bore rider bullet so I wasn't worried about encountering pressure spikes.............
Loaded up single rounds with charges shown above, fired with Magnetospeed chronograph attached for velocities, signs of pressure found in the 94.0 gr load with bolt lift a bit tighter than normal and a faint full moon mark on case head visible if held at the correct angle in the light, stopped there and did not shoot loads 94.5 thru 96.0 gr, backed down to 93.0 gr and fired 5 shots at 100 yards without Magnetospeed attached for an awesome group caught on video, I believe I need not mess with this load anymore until I see what it does at 500 plus yards..... did not have any water jugs to shoot at the time but have more ammo loaded and will blast some on the next trip out .........

should be a good load for squirrels and ptarmigan !

short video clip up on youtube.... https://www.youtube.com/watch?v=3xd_raiJxbg&feature=youtu.be
 

Attachments

  • CEB 265 MTH-1.jpg
    CEB 265 MTH-1.jpg
    194.9 KB · Views: 386
  • CEB 265 MTH-2.jpg
    CEB 265 MTH-2.jpg
    79.4 KB · Views: 299
  • CEB 265 MTH-3.jpg
    CEB 265 MTH-3.jpg
    149.1 KB · Views: 323
  • CEB 265 MTH-4.jpg
    CEB 265 MTH-4.jpg
    79.5 KB · Views: 948
  • CEB 265 MTH-5.jpg
    CEB 265 MTH-5.jpg
    111.6 KB · Views: 339
  • CEB 265 MTH-6.jpg
    CEB 265 MTH-6.jpg
    93.5 KB · Views: 328
More load development with the 338 Edge, this time it's the 265 gr Cutting Edge MTH Max bullets with a .800 bc printed on box....... Alliants Reloder 26 powder... case prep was the same as last time from the same batch of 300 RUM Norma brass, new unfired just necked up.....
http://www.longrangehunting.com/forums/f19/chinchaga-338-cal-300-gr-338-edge-rl33-171543/

338 Edge 30" 9.5 tw Obermeyer barrel
COAL 4.070" CBTO 3.182" (.020" jump)
Reloder 26 powder in all loads, Fed 215 mag primers from late 1990's bricks I had stashed in ammo cans and forgot about, they still work ! my Y2K stash came in handy, hahaha !

87.0 gr 2839 fps
87.5 gr 2857
88.0 gr 2873
88.5 gr 2908
89.0 gr 2918
89.5 gr 2927
90.0 gr 2967
90.5 gr 2981
91.0 gr 2983
91.5 gr 3019
92.0 gr 3039
92.5 gr 3063
93.0 gr 3075 (node)
93.5 gr 3119
94.0 gr 3123 (faint signs of pressure, stopped shooting)

This is a single shot load due to the OAL of the loaded cartridge..
the 265 gr bullets were seated just off the case mouth and the Hornady OAL gauge with the #33 comparator shows .020" off the rifling but it's a bore rider bullet so I wasn't worried about encountering pressure spikes.............
Loaded up single rounds with charges shown above, fired with Magnetospeed chronograph attached for velocities, signs of pressure found in the 94.0 gr load with bolt lift a bit tighter than normal and a faint full moon mark on case head visible if held at the correct angle in the light, stopped there and did not shoot loads 94.5 thru 96.0 gr, backed down to 93.0 gr and fired 5 shots at 100 yards without Magnetospeed attached for an awesome group caught on video, I believe I need not mess with this load anymore until I see what it does at 500 plus yards..... did not have any water jugs to shoot at the time but have more ammo loaded and will blast some on the next trip out .........

should be a good load for squirrels and ptarmigan !

short video clip up on youtube....

why the coating?????
 
Warning! This thread is more than 6 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top