338 edge at 1246 yards

Will do. There's a match next saturday, but I'm not sure I'm gonna make it. Scheduled to work that day.
 
Its ok,i was going to change it to a chassis or mcmillan but I'm pretty happy with how it shoots so I'll probably just leave it
 
Nope it's Va. We got steel at 600,825,920,1246 and soon at 1500.Remington brass neck sized,H1000 in the 90s the other edge i loaded for pressured out at 90,215 primers and velocity 2882 verified by AP ballistic.I'm going to check it again at 1500 and 1760 if i can get a target set up at that range.
 
Nope it's Va. We got steel at 600,825,920,1246 and soon at 1500.Remington brass neck sized,H1000 in the 90s the other edge i loaded for pressured out at 90,215 primers and velocity 2882 verified by AP ballistic.I'm going to check it again at 1500 and 1760 if i can get a target set up at that range.

Remember how much of a jump the bullets getting?
 
I'll have to check my note book when i get off work.I think some where around 20 thousandths.

Thanks, would be appreciated. Working up a load for a buddies 338 Edge with McGowan barrel screwed to a Savage action, and bullets, seating depths all over the internet look like people are running them between .015-.060... But wanted to narrow it down, we are starting with H1000....
 
Warning! This thread is more than 10 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top