dfanonymous
Well-Known Member
- Joined
- Jul 16, 2016
- Messages
- 2,025
I'm just going to start with this, if the only thing you can contribute is a sako extractor you can go eat a d!ck and I will ignore you.
Alright, extractor (rivet) broke sometime ago, finally got around to doing the replacement. Got it on, got it riveted. Its all good. just a little tight. So it push feeds, and if I force it, it will chamber. When I pull it a loaded or empty casing it works. It's too tight however to chamber. Any suggestions on how to tune it so it can get over the rim but not having to push it so hard?
chambered in .300 wm.
Alright, extractor (rivet) broke sometime ago, finally got around to doing the replacement. Got it on, got it riveted. Its all good. just a little tight. So it push feeds, and if I force it, it will chamber. When I pull it a loaded or empty casing it works. It's too tight however to chamber. Any suggestions on how to tune it so it can get over the rim but not having to push it so hard?
chambered in .300 wm.