New invention for stuck case removal , that doesn’t work

cornshank

Well-Known Member
Joined
Dec 25, 2021
Messages
1,241
Location
california
Don't take bolt cutters and cut old drill bit end off ,put in die and pound with hammer ,to remove stuck case .
You will probably end up with a new improved RCBS wood bit , that will still fit in press , but doesn't do anything.
Can't use bit anymore either .
BC7FAD29-F870-43DF-B497-A2916F1F963B.jpeg
D1B5C58F-5BBD-4631-A404-92945D159F00.jpeg
493E30D0-63C5-4539-A1F7-2E830F6EDEDD.jpeg
 
Pound out stuck case removers never work for me - I bought a tap,bolt to match tap, nice sharp twist drill, & washers from Home Depot - that with a hacksawed steel pipe of a slightly smaller diameter of the die, a dab of wheel bearing grease & a crescent wrench extracted the stuck case. Now I am looking for some very large threaded primers.
 
Last edited:
What Seabeeken said above is what I used to do and will do if I ever have it happen again. Now I take my new dies apart and celan them well before first use, and then I make sure I use the correct sheel holder and lube the case with a fine film, and no more stuck cases. Does ruin your day to have one pop put of the shell holder.
 
At least it is in the cheapest group to replace. I have stuck a total or two cases in 50 years. Both times it was when everything was closed. The SECOND time I had a stuck case remover and was back in business in short order. We really don't need to discuss the first time, but the experience was similar to the above.
 

Recent Posts

Top