Which 338 lapua improved?

To what? When done you will have to buy a set of custom dies that will not fit your next chamber. Buy your own reamer first.

to go from my 338 lapua to a 338ax. it would cost me 300 to have him make me a set of dies also. so about 420 for the whole package.
 
to go from my 338 lapua to a 338ax. it would cost me 300 to have him make me a set of dies also. so about 420 for the whole package.

Get two reamers, resizing and finish, if you are going that route. If you run a finish reamer in a sizing die blank it will be too big to properly resize your brass.
 
Thats a good point. My gunsmith knows all that im sure. He would be the one purchasing the dies and doing the work. Im just not sure if i want to invest another 500 in this rifle. Dont know if the gains justify the cost. What do you guys think?
 
Warning! This thread is more than 12 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top