Shoulder bump problem or no problem?

[Barehandlineman11]

If the case you have on hand is sizing to hard id run it through it and try it. No forming needed. Itll most likely push shoulder back out a couple thou

 

[Shane Lindsey]

So do you use the 30 Nosler die to size the body and then bump the shoulder with the Sherman die? Or other way around, bump shoulder and then size the body with the Nosler die?

 

[Tidesloe]

I haven't tried 2 die sizing yet, but I will this weekend. I'm gonna get plenty of pieces to work with, instead just a few.

 

[Barehandlineman11]

So do you use the 30 Nosler die to size the body and then bump the shoulder with the Sherman die? Or other way around, bump shoulder and then size the body with the Nosler die?

Run in nosler then sherman

 

[Tidesloe]

If anyone is still hanging around this thread, I have an update. We're finally getting somewhere on it. The reamer that cut my chamber is out of spec, pretty bad. Supposedly it's on its way back to Rich and then back to the reamer manufacturer. I'll loose a little barrel length to clean it up, but with a good reamer it'll be fixable

 

[ChrisInKY]

If anyone is still hanging around this thread, I have an update. We're finally getting somewhere on it. The reamer that cut my chamber is out of spec, pretty bad. Supposedly it's on its way back to Rich and then back to the reamer manufacturer. I'll loose a little barrel length to clean it up, but with a good reamer it'll be fixable

Am glad there's an answer and a solution to the problem. Would have been much worse for you had it remained a mystery.

Cheers,
Chris