Neck Turning

[texasgunner]

Guys, thinking of getting into neck turning. Any advice on brands etc. K&M look good, but I know little about setup. Any help
would be good.

 

[MagnumManiac]

I have the Sinclair and K&M.
Either gets the job done, the Sinclair feels better for me, but I have hand issues.

Cheers.

 

[Orange Dust]

I have RA. I use a Forster trimmer with a neck turning attachment. Does a fantastic job and I can run through 100 cases in nothing flat without pain. Doing the primer pockets and flash holes is another story though.

 

[DUSTY NOGGIN]

youll be glad you did .. lotta vids on the YouTube about it , some better than others .. watch a few

just dont cut em too thin

 

[dok7mm]

Been using K&M for many years with zero problems running tight neck and no turn neck chamber reamers. I try turning for no more than .004/.005" clearance.

 

[GLTaylor]

#2 for Sinclair's

 

[L.Sherm]

K@m here, I like it.

 

[Mikecr]

Sinclair is a 1-stop-shop for this kind of stuff.
A good book to read about neck turning and more is 'handloading for competition'

Amazon.com

 

[GLTaylor]

By the way, all. We lost another special person. Mr. Zeidecker just passed away recently.

 

[GW Hunter]

I just started to neck turn after avoiding it for years. Bought a PMA set up. So easy to set up and use. I use a small battery powered handheld screwdriver with their case holder. Perfect speed...

 

[MattK]

PMA Tool!

 

[texasgunner]

Ok guys, thanks for all the input, have another question. I shoot a 22-250 with neck angle of 28* What cutter angel do I
want. Do not see a cutter with that angle.

 

[Orange Dust]

The cutter doesn't need to match. They never do. You run it just into the shoulder just a little to prevent the dreaded donut. Not much, just a little, maybe a couple of thousands at the most. I'm sure there is a figural amount but I've always just winged it

 

[horse killer]

You can get a PMA neck turner with a 28* cutter blade