A&D FX-120i users....Let’s hear from you!

I'm sure the granite plates will work well. I use oversize mouse pads. I can still observe there is a difference if I move my chair around to a new position or if I change air conditioner or fan alignment in the room. The Fx-120i is a sensitive scale but I take that as a good thing.
Too be honest, I am less worried about it's absolute accuracy than I am about it's consistency when I am loading up a batch of ammo. The FX-120i seems to do well, but I have my doubts that the Area 419 "accessories" I ordered after getting my V3 are helping. I would have a hard time recommending them to a friend considering what they cost.
What accessories do they make?
 
If you get a reading like you did of 100.001g just do the calibration again. Mine does the same occasionally and if I redo the calibration it always reads the correct weight.

....and you were correct, Sir! Thanks so much. ;)
1F32F55C-471E-4073-8253-C9A10D8EFB5F.jpeg
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top