I built a 270 Sherman short mag on an older model 70 push/control feed, the problem is the gun doesn't extract properly. I assume it's because the rim on the ss is smaller than the original wsm case. Is there any easy fix to this?
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
270 SS model 70 help
- Thread starter 6mm06guy
- Start date
Help Support Long Range Hunting Forum
Rhett Crider
Well-Known Member
Is it not grabbing the rim and pulling out the cartridge? Assuming that all bolts are same diameter, possibly trying a standard cartridge extractor that may need to be modified? By a competent gunsmith. May need to be re-hardened, not sure. All my M-70 chamber changes have been CRFs so no real experience from me on your set up. MGW shows 3 different extractors w/ only one for magnums so that would make me think extractor cut when chambering the barrel, but I don't know if PP/CRF uses extractor cut either.
www.midwestgunworks.com
www.midwestgunworks.com
Hopefully a gunsmith w/ WIN PP/CRF experience will chime in for you.
Winchester Model 70 Push Feed Extractor, Standard Calibers (1)
Check out the deal on Winchester Model 70 Push Feed Extractor, Standard Calibers (1) at MGW
Winchester Model 70 Push Feed Extractor, Magnum, WSM, and WSSM (2)
Check out the deal on Winchester Model 70 Push Feed Extractor, Magnum, WSM, and WSSM (2) at MGW
Hopefully a gunsmith w/ WIN PP/CRF experience will chime in for you.
It pulls it out every time, but it drops it about 1/2 way back.Is it not grabbing the rim and pulling out the cartridge? Assuming that all bolts are same diameter, possibly trying a standard cartridge extractor that may need to be modified? By a competent gunsmith. May need to be re-hardened, not sure. All my M-70 chamber changes have been CRFs so no real experience from me on your set up. MGW shows 3 different extractors w/ only one for magnums so that would make me think extractor cut when chambering the barrel, but I don't know if PP/CRF uses extractor cut either.
Winchester Model 70 Push Feed Extractor, Standard Calibers (1)
Check out the deal on Winchester Model 70 Push Feed Extractor, Standard Calibers (1) at MGW
Winchester Model 70 Push Feed Extractor, Magnum, WSM, and WSSM (2)
Check out the deal on Winchester Model 70 Push Feed Extractor, Magnum, WSM, and WSSM (2) at MGW
Hopefully a gunsmith w/ WIN PP/CRF experience will chime in for you.
