Thoughts

Excavator

Well-Known Member
Joined
Nov 28, 2016
Messages
138
i am thinking about drilling a hole in the corner of my Legacy shooting table. Sticking a 1/4-20 bolt through it. With a nut on the top. Leaving about 1/2-1" of threads exposed. To screw my lab radar to. Is this a bad idea? Thoughts?
 
I have done something similar for other reasons......but I can't explain it very well. I think this sketch should though. Basically the nut keeps the thumb bolt from falling out and getting lost, but the table top remains flat when nothing's attached. Just another way to skin the cat, I guess.
20190118_125152.jpg
 
Warning! This thread is more than 6 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top