Target Steel

i dont want to hijack the thread. but i have a question for those of you who hang their steel. i made a stand and got some old fire hose cut a hole in it and put a bolt though it and the steel. well i went out shooting the other day and hit close to the bolt and the steel flew off. so my question is how are you guys hanging/attaching your steel plates?

I'd weld on some washers and use a chain or chains....

Conjures up thoughts of my marksmanship... I invaribly break the wires that hold the targets for indoor match pistol. We use a wire across the top and bottom and clothespins to hold targets and warming up, I seem to 'snip' them regularly.....

....The 'splash' you are looking for would be enhanced by using drawing quality (10X or better steel) because the steel can elongate when the projectile hits it. That will fracture off the paint layer quite nicely.....
 
i dont want to hijack the thread. but i have a question for those of you who hang their steel. i made a stand and got some old fire hose cut a hole in it and put a bolt though it and the steel. well i went out shooting the other day and hit close to the bolt and the steel flew off. so my question is how are you guys hanging/attaching your steel plates?

Most e economical way I've found is steel fence posts. They're cheap, like $4-5 bucks a piece, & re useable, plus you can put them anywhere you can pound em into the ground. I have chains on my targets, & use bailing wire (tie wire) to adjust the links so the steel hangs evenly.
I've even used a tree branch & mule tape to hang steel from a tree limb. I would NOT recomends this method. When the bullets impact the steel they basically blow up. (even my Accubonds). You can guess where the fragments ended up when you go to untie the mule tape, & your hands look like you swatted a porcupine.
Chains are about the only good way I've found.
 
http://i1117.photobucket.com/albums/k598/dean2506/photobucket-4638-1330994992280-1.jpg

I just built this last weekend out of some conduit. The bottom pieces highlighted with yellow slide out of the stand so it can fold up. It is very stable. We used them this weekend at 300 and 400 yds and they held up great. The steel on the other hand didnt do very well it was plain steel. I ordered some ar500 to put on them and will build a few more.
 
YOUR AR400 ain't like MY AR400!!

Me thinks you've taken a 'bend-over'!!

Fortunately I haven't bought anything yet. This was a scrap piece. Every thing cut from a sheet gets marked if it is AR or T1 so we know what it is. It is entirely possible it could have been mismarked. I can check it against a full sheet that has the grade marked on it. It would be nice if it proved to be a lower grade, then maybe 400 would work just fine. Cliff
 
Warning! This thread is more than 13 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top