Stand for reloading press

[squeeeeze]

I have a Hornady AP Progressive press on the way but out of real estate on my reloading bench. I am looking for a freestanding stand. Does anyone know if this Lee stand is any good and will the Hornady AP bolt up fine on it? Very sturdy?

Anything I need to know or consider a different stand?
https://www.amazon.com/LEE-PRECISIO...coding=UTF8&psc=1&refRID=BWZKN3P7XHKTC19BCYCP

 

[Mrvmax]

Don't know about that one but I would go with Inline Fabrication.

 

[squeeeeze]

Don't know about that one but I would go with Inline Fabrication.

I'm not seeing a freestanding floor stand from them, just ones that go on the bench. Do you have a link to one I can check out? Heard good things about inline.

 

[Axl]

I have the Inline fab. plate flush mount that I routed out my bench for. I switch between the Horn. AP, Forster COAX, Rcbs RC, and a vise. The presses not in use hang on the inline brackets on the side or under my bench. And if you need you can have a flat bench to do other things.

 

[Mrvmax]

I'm not seeing a freestanding floor stand from them, just ones that go on the bench. Do you have a link to one I can check out? Heard good things about inline.

Sorry, I was thinking about their quick mount system where you only use one spot on your bench and swap out presses, trimmers, vise etc. I don't think they make a floor mount

 

[squeeeeze]

I'll have to look into those quick change system and consider them. Sound pretty slick.

 

[DocDoc]

And the Inline makes it easy to take a press to the range to do some development. It also works well in other small spaces in the home.

 

[QuietTexan]

I have the Lee stand, and it's solid. I also one of these:
https://www.harborfreight.com/universal-bench-grinder-stand-3184.html
Both work fine. The Lee stand has two concrete blocks for weight, the grinder stand I use metal or sandbags (it's not always set up).

I'd prefer a bench mount, but these work fine.