h-s length of pull

Greywolf18

Well-Known Member
Joined
Dec 18, 2008
Messages
361
Location
New Bern, NC
I was looking into ordering an H-S stock for a model 70 I want to start doing a custom job on. When going to order they ask for the length of pull. How exactly do I get this? I've never done a custom rifle before, and there isn't a gunsmith close by so I figured I'd ask on here. All I have is the factory stocks on all but one of my guns, and the one has a B&C Medalist so I have never had to deal with this. Thanks for the help!
 

Doug in Alaska

Well-Known Member
Joined
May 31, 2009
Messages
138
Location
Wasilla, Alaska
I have three H-S stocks and have always ordered the standard length of pull which I believe is 13.5". If your factory stocks are working for you, I'd think the standard pull length for the H-S will also. If standard won't work the easiest way to determine your length of pull is to measure the distance from the inside of the elbow to the index finger that is bent to simulate it being on the trigger.
 
Warning! This thread is more than 13 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top