• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Brass failure after 2 loads normal?

TBuckus

Well-Known Member
Joined
Jun 12, 2012
Messages
393
Location
OR
I just finished cleaning and resizing some 7mm-08 R-P brass getting reading for a third load and ran into a few that the neck was cracked the whole length.

Is this normal to have a few failures from cheaper brass? They were factory loads and the second reload were not that hot. I was just hoping that I could get 3 or 4 loads out of them.
 
I've noticed that the necks of the factory loaded R-P brass I have just started using, needed some annealing; (the neck tension wasn't as tight as I wish.) Once I annealed them they were fine.

Maybe it is normal for R-P cases from loaded cartridges, I've never bought R-P bottleneck cases. I would anneal them and not look back.
 
Warning! This thread is more than 11 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top