FURMAN
Well-Known Member
I can't and won't say it matters or that I would ever notice but I think marine Tex is easy to work with so from my standpoint I might as well use it. I don't have any rifles that will shoot in the zeros.
Bedding
- Thread starter gkempf
- Start date
Very good article, with some very good responses after- especially about the aluminum bedding blocks.
codyadams
Well-Known Member
Thank you. I use a dremmel with a router attachment, and a lot of patience. Some of the places I use an attachment on the dremmel that allows a little more precision work, but that is only free hand, no router attachment.
John McLaughlin
Well-Known Member
I have two Weatherby Mark Vs (270 WM and 340 WM) bedded into McMillan stocks with Acraglas Gel over 10 years ago. I've not noticed any dimensional changes that have resulted in loss of accuracy. FWIW. JM
ntsqd
Well-Known Member
Devcon AL putty for me. I've previously posted the specs important to to me, and the links to where to get all of those specs from the Devcon page in a thread on release agents. It shrinks a little more than the steel putty, but it is stronger than it too.
Left Hand Dave
Well-Known Member
Anyone know of a good video that shows the proper way to bed and clean up? I tend to make a mess when I do things.
Dave
Dave
ntsqd
Well-Known Member
Search the couple previous threads on this topic. There is one particular video where the guy really seems to know what he's doing (he's acknowledged as a real expert in the field & I wish that I could recall his name). I personally do it differently than he does because I want the pillars to maintain the vertical positioning, but his method seems robust.
ntsqd
Well-Known Member
There, that is the link that I was remembering. Thank you.
Left Hand Dave
Well-Known Member
Thanks everyone.
Dave
Dave
I like the Pro Bed 2000 bedding compound from Score High gunsmithing in Albuquerque, NM. High quality, easy to work with, virtually no shrinkage, stable, and you can mix it to the thickness you want.
http://www.scorehi.com/epoxy-pillar.htm
http://www.scorehi.com/epoxy-pillar.htm
Last edited:
ntsqd
Well-Known Member
RE: Pro Bed, do they publish any shrinkage or strength specifications? I could not find any with just a few minutes worth of looking. It looks like a good product, but without numbers there's no way to quantify where this product exceeds or lags Devcon in particular.
Hey @ntsqd, I'd shoot off an e-mail to Charley Robertson and ask about the data you are seeking (shrinkage/strength specs.)
[email protected]
It's a small shop so he'll probably reply to you directly (himself.) So far, I've been really pleased with the product, but I know you are of an 'engineering' mind and need data, so give him a shout and see what he can share with you.
[email protected]
It's a small shop so he'll probably reply to you directly (himself.) So far, I've been really pleased with the product, but I know you are of an 'engineering' mind and need data, so give him a shout and see what he can share with you.
