I have recently purchased a ZCO scope and need a 36mm scope base. I already have a 10 MOA rail installed on my 6.5 CM rifle and would prefer to continue to use the rail. So I was looking for a 10 MOA scope base for the ZCO to give me a total 20 MOA cant for the scope. The only 10 MOA base I've been able to find is an ARC M-Brace mount. I have no experience with this company but the mount looks like it is constructed very well. Any feedback on the ARC mount or any other suggestions for a 10 MOA mount would be appreciated. Thanks.
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
ARC M-Brace Scope Mounts for ZCO Scope
- Thread starter samcleod
- Start date
Help Support Long Range Hunting Forum
Some of the best rings on the market. Have the rings but not the mount but I would assume it is top notch as well. Run the rings almost exclusively on my guns anymore.
mudflap621
Well-Known Member
I run both their rings and mounts, they are some of my favorites.
erhyne
Member
I like all of ARC's products. Top quality. I have the older version of the rings and mounts on a custom build 300 WM and recently ordered the M-Brace for a new rifle that I am building.
lancetkenyon
Well-Known Member
ARC M10/M-Brace have become my go-to rings. Inuse them for 30mm, 34mm, and 36mm tubes on my personal rifles.
With the amount of elevation travel available in the ZCO, do youbreally need the additional 10MOA of the 1-piece mount? Or can you get away with rings? I shoot my 6CM out to 1500+ with a scope that "only" has 12MIL of elevation available. And shoot my 6.5SLR at the same distance and never need to hold over.
Depending on which model you got, with the 10MOA rail, the 4-20/5-27 should have approx 20MIL/70MOA, the 8-40 has approx 17MIL/57MOA of elevation.
On a side note, MK Machine makes a nice 36mm aluminum level.
With the amount of elevation travel available in the ZCO, do youbreally need the additional 10MOA of the 1-piece mount? Or can you get away with rings? I shoot my 6CM out to 1500+ with a scope that "only" has 12MIL of elevation available. And shoot my 6.5SLR at the same distance and never need to hold over.
Depending on which model you got, with the 10MOA rail, the 4-20/5-27 should have approx 20MIL/70MOA, the 8-40 has approx 17MIL/57MOA of elevation.
On a side note, MK Machine makes a nice 36mm aluminum level.
RockyMtnUT
Well-Known Member
Another vote for the superb quality of the ARC rings!
Some of the best rings made. I have them on 3 rigs I own.
I have a couple sets of rings. They are very well made
