7 wsm brass

Levi

Well-Known Member
Joined
Nov 26, 2007
Messages
158
Location
Idaho
Can anybody help me find some brass for the 7 wsm? I have been looking for six months, but to no avail...getting frustrated. Any help would be greatly appreciated.

Levi
 
Is the brass that you have stamped 7 wsm? If so, would you be willing to sell me it? The 270wsm has different case dimensions.

Levi
 
Is the brass that you have stamped 7 wsm? If so, would you be willing to sell me it? The 270wsm has different case dimensions.

Levi

Levi,
The new unfired 7wsm stamped. It has to be found in my stuff after moving. I would prefer to getting new 270 wsm brass and trade, Other wise I will have to wait to find some myself. Price is another section for discussion.

21buck
 
I use Norma 270 or 300wsm brass in my 7mm. It's a very simple fireform. Much better quality than any other brass.

Here's the extent of the fireform. Note the placement of the false shoulder compared to the formed brass. I ran my fireforming loads at full strength and got better than acceptable accuracy.

 
I use Norma 270 or 300wsm brass in my 7mm. It's a very simple fireform. Much better quality than any other brass.

Here's the extent of the fireform. Note the placement of the false shoulder compared to the formed brass. I ran my fireforming loads at full strength and got better than acceptable accuracy.

How do you do that ? I'm running low on 7wsm brass
 
Another option is to buy loaded ammunition -- it can be found , and at $30.00 for 20 rounds of Federal it is cheaper than buying Hornady or Norma brass. Then either shoot it or pull the bullets and re-load. Headstamps will be correct that way.
 
What about using 270 WSM ?

I was thinking I was talking about the 300. If I was going to use 270 I would size up to 7mm then to 300 and back to 7mm. You could try to go straight to 30 cal not sure if it would be to big of a jump or not. I would only want to do 300 wsm
 
How do you do that ? I'm running low on 7wsm brass

Yep, just like Huntfarther said. Neck down 300 brass, or neck up 270 to 300 then back down.

When you're setting up the false shoulder you're using your 7mmWSM FL die turned out a couple turns. Keep sizing down the neck until you can just close the bolt with some resistance. Then, you're ready for primer, powder, and bullet.

Like I said, I've gotten very good accuracy and velocity even when fire forming.
 
Warning! This thread is more than 11 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top