desertbull
Well-Known Member
- Joined
- Jul 25, 2010
- Messages
- 251
Can someone recommend a shop to have my 700 action worked over. Too many to choose from with a wide variance in pricing has my head spinning.
Thanks
Thanks
Rem 700 blueprint
- Thread starter desertbull
- Start date
Help Support Long Range Hunting Forum
You cannot go wrong with any of the sponsor gunsmith here. Good luck!
Ed
Ed
JUDD
Well-Known Member
Kevin Cram of Montour County Rifles.
He does all my work. Very very good smith he knows what he is doing is will give you more then enough info on your work.
570-437-2010 is his shop number
He does all my work. Very very good smith he knows what he is doing is will give you more then enough info on your work.
570-437-2010 is his shop number
Here are prices posted by a very good gunsmith - Sid Goodling
Fit and Chamber Barrel including crown and basic polishing of barrel $150.00
Special finish or High polish on barrel $50.00 & up
Inlet stock $100.00 & up
Pillar Bedding $150.00
Glue ins including pre-bedding $200.00
Custom Bullet seater Die from same reamer as chamber $125.00
Custom Sizing Die $175.00
True Remington Actions $150.00 & up
Muzzle Brake $150.00 & up
Basic Machine and Gun repair work $50.00 Hr.
Prices subject to change.
Fit and Chamber Barrel including crown and basic polishing of barrel $150.00
Special finish or High polish on barrel $50.00 & up
Inlet stock $100.00 & up
Pillar Bedding $150.00
Glue ins including pre-bedding $200.00
Custom Bullet seater Die from same reamer as chamber $125.00
Custom Sizing Die $175.00
True Remington Actions $150.00 & up
Muzzle Brake $150.00 & up
Basic Machine and Gun repair work $50.00 Hr.
Prices subject to change.
Kevin Cram
Well-Known Member
desertbull,
If you give me a call it's easier to explain how I blueprint an action on the phone rather than type it out. I use all GTR tooling and single point re-cut all surfaces to less than .0002" run out from center line. I'd be more than happy to do the work and answer any questions you have.
Montour County Rifles (570) 437 - 2010
If you give me a call it's easier to explain how I blueprint an action on the phone rather than type it out. I use all GTR tooling and single point re-cut all surfaces to less than .0002" run out from center line. I'd be more than happy to do the work and answer any questions you have.
Montour County Rifles (570) 437 - 2010
ICANHITHIMMAN
Well-Known Member
I have two of Kevins rifles
