New Brass

300 ultra

Well-Known Member
Joined
Apr 17, 2010
Messages
839
Location
OREGON
I purchased some new winchester brass and I had to trim well below minimum book trim length to square up. Is there issues with doing this? It is 30-06 brass. Is this common with winchester brass? Should I have just left it and fired it and then trimmed after firing? Appreciate replies...
 
I frequently have to start my brass short in order to get uniformity which I need for flash hole deburring, chamfering and consistent neck tension. Shouldn't hurt anything. I have never had any trouble from it but as case grow I trim accordingly to let them grow out.
 
I just had similar situation with new Remington Brass for .280

Rule of thumb is that minimum necessary is neck length = to bullet diameter.

While I would prefer long enough to trim and prep and have more than enough....as long as I get that value, in this case .284 neck length or greater I am OK.

Edited.....

For your case, .308 length would be your minimal aim....my recent experience was with 7mm thus .284.
 
Last edited:
300 Ultra,

You mention "well below minimum" but you didn't specify exactly what that may be. If it's a matter of .015"-.020" or so, that's not likely to be any problem at all. What is the final length you're coming up with when the brass is completely uniformed?

Seriously doubt that this will cause you any problems, but would like to know what sort of dimension you're dealing with here.
 
Barnes used to put a note in w/bullets saying set a minimum of 1/3 the diameter I think.Anybody remember this?OR WAS THAT 2/3 sorry, ?
 
I've found It to be very common with Winchester lately, I have had up to 8% defective rate with win. brass in .223/.308/22-250/9mm, etc. Case mouth deformation, flash hole not punched, No primer pocket, deformed (folded) shoulders, etc. Called cust. service, asked me to send samples back, I did, they sent me a "coupon" for $10.00 and said " sorry". In my business, an 8%+ failure rate is unheard of !
 
Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top