Have a box of new lapua brass went to prime some. They are the hardest to put primers into primer pocket I have seen. I was struggling getting them in far enough with my press even. I have the primer pocket go/no-go tool. I couldn't get the go side in. I guess what's the solution? I have not run into this issue before. I'm guessing there is a tool to fix this?
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Lapua primer pockets
- Thread starter MT257
- Start date
Help Support Long Range Hunting Forum
I have a Lyman primer pocket uniformer. It fits in fine. It's like the pocket isn't wide enough. Would a different brand be able to fix this?
I'll give some cci 200 a whirl.
Put a cci in this morning. Went in with press snuggly but much easier compared to the Fed 210.
ShootnMathews
Well-Known Member
Fed 210 are always tight for me.
birddog 68
Well-Known Member
I'd be more than willing to trade some of my normal size CCI 200's for some oversized federal 210's if anyone is interested. 
ShtrRdy
Well-Known Member
Give Capstone a call or send an email. You're not the first one to experience this and they should know what we're dealing with.
dkuls
New Member
Had the same problem with new Lapua 300PRC brass. Gave them a light touch with military crimp remover and all was well
