• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Is this acceptable?

  • Thread starter Deleted member 107666
  • Start date
D

Deleted member 107666

Guest
No intent to be a Karen...honestly not sure if this is an issue or fairly standard. Seeking opinions. Bought new from a reputable gunsmith/company, just got delivered today...is this acceptable or would you return it? Pretty decent drop/ding.

Would this be a non-issue after it's chambered and spun on?







 

Attachments

  • 1670705527010766912060191409303.jpg
    1670705527010766912060191409303.jpg
    976.9 KB · Views: 209
Last edited by a moderator:
Thanks for the input, just wasn't sure if it would affect threading at all.
Would have been nice if they'd packed it a little better (the last 3 blanks I ordered, 1 from Altus and 2 from Bugholes) took probably 15-20minutes to get into they were packed so well), but most barrel manufacturers instruct you to cut off the .25-.5 from each end of the blank before chambering/threading anyways so that part wont even be used. Annoying but GTG
 
Would have been nice if they'd packed it a little better (the last 3 blanks I ordered, 1 from Altus and 2 from Bugholes) took probably 15-20minutes to get into they were packed so well), but most barrel manufacturers instruct you to cut off the .25-.5 from each end of the blank before chambering/threading anyways so that part wont even be used. Annoying but GTG
Nothing too worry about
 
No intent to be a Karen...honestly not sure if this is an issue or fairly standard. Seeking opinions. Bought new from a reputable gunsmith/company, just got delivered today...is this acceptable or would you return it? Pretty decent drop/ding.

Would this be a non-issue after it's chambered and spun on?







Not a problem
 

Recent Posts

Top