I need help

[sailorjim]

I screwed up 20 rounds. I need to pull bullets, dump powder, and de-cap unfred primers. Who makes the best bullet puller and how do I de-cap unfired primers? Thanks

RCBS collet puller has worked better than anything else I've tried.

 

[Roughrice]

Been there, done that!

I used inertia hammer to pull without damaging bullets and merely neck sized or FL sized without a decap pin.

No worries!
It's happened to everyone who has hand loaded lots of ammo!

 

[JustMe2]

I bought both pairs... can't get the mag set to pull a feather!

Yes, that's why I modified mine with a thick wooden grip. The unmodified grip cut into my soft delicate hands, which hurt, causing me not to squeeze the grip hard enough to grip the bullet.

 

[Roughrice]

FYI…
I have (in the past) mistakenly neck sized and loaded some ammo that was fired in my other 308.
After loading a box of 20, I realized they would not close in intended chamber so I broke them down and fl sized without decapping one at a time and reloaded with the same powder and bullet.
Worked out fine.

 

[skipglo]

Yes, that's why I modified mine with a thick wooden grip. The unmodified grip cut into my soft delicate hands, which hurt, causing me not to squeeze the grip hard enough to grip the bullet.

Noted..... I will give it a try....with 2 Uniform adapters!

 

[hydehunter]

and when the RCBS puller finally breaks tears down the road they will send you another one for free

 

[Husky user]

I was able to resize 16 7mm mag cases after pulling bullets by just taking the primer pin out of the resize die.
No problem,and I adjusted the load and reloaded them,work fine now!

 

[Lenny Foffa]

I love my RCBS Puller, with all my collets. Works perfectly for over 40 years. Never an issue . Get a collet for every caliber you own!!! and YES, you can reuse the bullet you pulled, most of the time. Many times no marks on the bullet at all. Look at what 436 sent you !! I kick out live primers using the RCBS Resize and de priming die. I put a big thick towel over the press then GENTLY and SLOWLY run the handle down till the primer drops in to the CLEAN plastic tray. Yes, I will reuse the primer, once the issue with my brass has been resolved.

 

[willtim]

I bought a RCBS inertia puller and it worked flawlessly. I saved bullets, powder, primers, and cases. Thanks for all of the advice.

 

[Mike Matteson]

I bought an inertia puller and it took care of 20 rounds with no trouble.

i have taken down about 50 rounds with a ineritia puller. No problem just work. Had a temp problem with some powder.