Cleaning Chamber

[KTP]

I feel like I've got a good handle on the barrel cleaning process but often wonder if I'm doing a good enough job cleaning the chamber.
What process do you use for chamber cleaning?

 

[ShtrRdy]

Are you wondering about a bolt gun or a semi-auto gun such as an AR?

 

[KTP]

Bolt gun

 

[ShtrRdy]

From my experiences cleaning a bolt gun, the cartridge brass should seal off the chamber. You will get the carbon build up in front of the neck and in the leade area. Therefore I only worry about carbon build up in the neck area of the chamber. Allowing Bore Tech Carbon Remover to soak on the spot overnight a couple times really takes care of it.

 

[bill123]

From my experiences cleaning a bolt gun, the cartridge brass should seal off the chamber. You will get the carbon build up in front of the neck and in the leade area. Therefore I only worry about carbon build up in the neck area of the chamber. Allowing Bore Tech Carbon Remover to soak on the spot overnight a couple times really takes care of it.

This plus I swab out the chamber using a large mop with paper towel wrapped around it to make sure the chamber is dry.

 

[cajun]

After cleaning I run a large patch on a jag in the chamber to clean out any residue. Using a good bore guide helps.

 

[KTP]

After cleaning I run a large patch on a jag in the chamber to clean out any residue. Using a good bore guide helps.

That's what I've been doing too. Just needed a gut check if there was a better way that I've missed