Shane Lindsey
Well-Known Member
- Joined
- Jul 13, 2010
- Messages
- 3,344
Greetings,
Anyone loading monos at lightspeed in a RUM?
I have a 28" 300 RUM with a 12 twist, no brake on an older Christensen barrel (no meat at the end for a brake unless I use a clamp on). I am constrained to using light for caliber due to twist rate, but the rifle is 8# 2oz as I wanted and recoil with the lighter weights isn't terrible. I purchased this off GB and really didn't do my homework...Long story and not what this thread is about.
I have loaded quite a few different loads up to the 200 gr Gk as that was about what I could potentially stabilize. Just not liking what I see.
I found a load with the ...wait for it...152 Hammer Hunter and like all other rifles I have tried them in , it shoots them very well.
Just curious if anyone has gone this route also.
Thanks,
Stay safe and wash your hands...
Anyone loading monos at lightspeed in a RUM?
I have a 28" 300 RUM with a 12 twist, no brake on an older Christensen barrel (no meat at the end for a brake unless I use a clamp on). I am constrained to using light for caliber due to twist rate, but the rifle is 8# 2oz as I wanted and recoil with the lighter weights isn't terrible. I purchased this off GB and really didn't do my homework...Long story and not what this thread is about.
I have loaded quite a few different loads up to the 200 gr Gk as that was about what I could potentially stabilize. Just not liking what I see.
I found a load with the ...wait for it...152 Hammer Hunter and like all other rifles I have tried them in , it shoots them very well.
Just curious if anyone has gone this route also.
Thanks,
Stay safe and wash your hands...