1911 Nitriding advice?

stanley52

Well-Known Member
Joined
Jan 20, 2013
Messages
284
Location
Southeast Kansas
I apologize as this does not relate to long range hunting, but I figured some good advice could still be found. I am interesting in nitriding a 1911, and I think most 1911's there would not be an issue. My concern would be for a tightly toleranced one like a Les Baer or Ed Brown. Being that tolerances are so tight, and nitriding can cause metal to feel rough and make it so **** hard, would your 1911's action then feel rough? Would it ever break it properly? Should you wait to nitride it till after it's broke in? Just cycle it a thousand times without firing it, and then nitride it? Or just don't do it at all?
 
Warning! This thread is more than 10 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top