birdiemc
Well-Known Member
Turning some necks today so I thought I would share my setup.
I pulled the ram from my lee handheld press. Looped that on a j bolt held by a chuck in the tailstock.
I turned down a mandrel with a shoulder to stop the brass forward movement, but the cutting tool clears it.
Use the ram in the tailstock to press the case onto the mandrel, then use it again to pull it back off.
I pulled the ram from my lee handheld press. Looped that on a j bolt held by a chuck in the tailstock.
I turned down a mandrel with a shoulder to stop the brass forward movement, but the cutting tool clears it.
Use the ram in the tailstock to press the case onto the mandrel, then use it again to pull it back off.