Barrel weights

TK 1985

Well-Known Member
Joined
Oct 18, 2015
Messages
192
Building a lightweight rifle. Obviously a featherweight barrel would be the lightest, but what would be a good barrel contour, that if fluted, would come close to the 2-2.5 pound mark? I know that's probably pushing it and 3 lbs. is probably more realistic. But would say, a #3 come close if fluted? A #4 or 5#?
 
Building a lightweight rifle. Obviously a featherweight barrel would be the lightest, but what would be a good barrel contour, that if fluted, would come close to the 2-2.5 pound mark? I know that's probably pushing it and 3 lbs. is probably more realistic. But would say, a #3 come close if fluted? A #4 or 5#?

I purchased a Pac-Nor 6.5mm barrel that matches the Weatherby Mark V six lug ultralight. The muzzle is about .550". It is 26" and weighed forty ounces before it was fluted by Twisted Barrel. They took another seven ounces out of it. It has a Terminator T2 brake. It weighs five pounds seven ounces without the scope.

The first time at the range was last Friday. I loaded up six rounds to discover the maximum load so each round contained one grain more than the previous one. I fired them at 300 yards. If the first one had not been high, the group would have been about 1 1/2" as it was shots #2, 3, 4, and 5 measured 1/3/8". When I include the first one the group opened to 2 7/8".

Before this one I had Pac-Nor make one exactly the same except it was .257 caliber. While testing primers I decided to fire three three shot groups at 100 yards. Then I decided to put them all on one target. The group was 7/8" across.

Light barrels can be fairly accurate.
 
See a couple places have said they will not flute a featherweight.

Everywhere I called, except Pac-Nor would not even make a barrel the weight I wanted. Twisted Barrel doesn't seem to care what barrel you send them. Despite mine being so small in diameter it is a mid-length magnum case.
 
I was wondering which design would reduce weight the most. The carbon fiber wrapped barrels are neat but for a mountain rifle I just don't think they would be very durable.
 
Well to be fair they did say it was only hand tightened, not torqued and indexed, just so they could take it on and off for the demonstration
 
Warning! This thread is more than 9 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top