WFT Trimmer

WapitiBob

Well-Known Member
Joined
Oct 16, 2011
Messages
427
Location
Bend, Or
nope.

A decent trimmer, adj is a pain with just set screws on the side of the end mill. Some shell case to unit ID slop so the case mouth won't be square to the shoulder but it isn't bad. Your case mouth is sitting in air anyway with both the id and od being chamfered. I like it a lot better than the standard trimmers I have.
 

rcoody

Well-Known Member
Joined
Jul 1, 2015
Messages
1,026
nope.

A decent trimmer, adj is a pain with just set screws on the side of the end mill. Some shell case to unit ID slop so the case mouth won't be square to the shoulder but it isn't bad. Your case mouth is sitting in air anyway with both the id and od being chamfered. I like it a lot better than the standard trimmers I have.

I use this one giraud tri-way New Page 1

very similar to the WFT but the tri-way does chamfer and debur

I used to hate trimming brass but trimming brass is no big deal with one of these
 

bob4

Well-Known Member
Joined
Nov 10, 2012
Messages
549
Location
Naples Fl.
Does the giraud tri-way trim any more square that the WFT ? Anyone using it in 270 or 300 wm?
 

Trending threads

Top