crappiedan
Active Member
Does the WFT trimmer chamfer and debur?
WFT Trimmer
- Thread starter crappiedan
- Start date
Help Support Long Range Hunting Forum
nope.
A decent trimmer, adj is a pain with just set screws on the side of the end mill. Some shell case to unit ID slop so the case mouth won't be square to the shoulder but it isn't bad. Your case mouth is sitting in air anyway with both the id and od being chamfered. I like it a lot better than the standard trimmers I have.
A decent trimmer, adj is a pain with just set screws on the side of the end mill. Some shell case to unit ID slop so the case mouth won't be square to the shoulder but it isn't bad. Your case mouth is sitting in air anyway with both the id and od being chamfered. I like it a lot better than the standard trimmers I have.
I use this one giraud tri-way New Page 1
very similar to the WFT but the tri-way does chamfer and debur
I used to hate trimming brass but trimming brass is no big deal with one of these
crappiedan
Active Member
I really like the giraud but didn't see one for the WSMs
he will make you one
bob4
Well-Known Member
Does the giraud tri-way trim any more square that the WFT ? Anyone using it in 270 or 300 wm?
crappiedan
Active Member
Has anyone tried these? RCBS Trim Pro Case Trimmer 3-Way Cutter 22 Cal
I used this one in my case trimmer before I found the Giraud
3 in 1 Cutter | Carbide Case Trimmer Accessory
put an electric screwdriver on it and it is not bad
but after you use the Giraud you will never want to trim brass any other way once again
and if you are a really high volume guy try this
GTC Trimmer
