Trigger Top Sear And Cocking Piece Contact Angle

Edd

Well-Known Member
Joined
Jan 26, 2011
Messages
3,814
Location
Tulsa
I have done some research about primary extraction and trigger timing on Model 700 actions. One of the details that has been mentioned is, when trimming the contact surface on the cocking piece you need to keep the angle the same as it was. I don't see any reason to be concerned what this angle is as long as the contact point remains at the bottom of the cocking piece. Can someone explain why you need this surface to be at a specific angle?
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top