cornstalker
Well-Known Member
SOLD!!
This is a stainless gun. It is in a Hogue overmolded stock with the full length bedding block. The barrel is free floated. It has a trigger job that was done professionally, but it is developing a little creep. The stock has some marks on it from hiking through scrub oak. The bolt release has some scratches on it where it rubbed up against my Kimber 1911 while climbing a mountain.
With 165 grain Hornady Interlock FB’s over IMR4064 it grouped at .679” (100yd). 165 Hornady over RL15 .817”, 165 grain Speer Boat Tail over RL15 .537”
I want to sell it or trade it off to continue other projects.
I will include:
Rifle with factory ring mounts and Hogue stock
Burris 3-9x40 Fullfield II
Hornady New Dimension Custom Grade dies, NIB
50 pieces Winchester brass, most once fired, some new and primed with CCI 200’s
17 or so pieces Federal brass 3x fired
A bag of military brass I don’t care enough to count.
A few Hornady 165’s a few Speer 165’s
2 snap caps
1 Stock bag
Asking $540 shipped for all. (to your FFL)
Looking to sell outright first, but...
Will consider trades/part trades for scopes or rangefinders. I also need a Savage action, short, small shank, stagger feed with a .378” bolt face.
Other stuff I would consider for partial trades:
Caldwell Rock BR
Tool for measuring concentricity/runout
RCBS Chargemaster Combo
Foxpro CS24
Sorry the pix are a little fuzzy. I can email more pix to someone who is seriously interested.
This is a stainless gun. It is in a Hogue overmolded stock with the full length bedding block. The barrel is free floated. It has a trigger job that was done professionally, but it is developing a little creep. The stock has some marks on it from hiking through scrub oak. The bolt release has some scratches on it where it rubbed up against my Kimber 1911 while climbing a mountain.
With 165 grain Hornady Interlock FB’s over IMR4064 it grouped at .679” (100yd). 165 Hornady over RL15 .817”, 165 grain Speer Boat Tail over RL15 .537”
I want to sell it or trade it off to continue other projects.
I will include:
Rifle with factory ring mounts and Hogue stock
Burris 3-9x40 Fullfield II
Hornady New Dimension Custom Grade dies, NIB
50 pieces Winchester brass, most once fired, some new and primed with CCI 200’s
17 or so pieces Federal brass 3x fired
A bag of military brass I don’t care enough to count.
A few Hornady 165’s a few Speer 165’s
2 snap caps
1 Stock bag
Asking $540 shipped for all. (to your FFL)
Looking to sell outright first, but...
Will consider trades/part trades for scopes or rangefinders. I also need a Savage action, short, small shank, stagger feed with a .378” bolt face.
Other stuff I would consider for partial trades:
Caldwell Rock BR
Tool for measuring concentricity/runout
RCBS Chargemaster Combo
Foxpro CS24
Sorry the pix are a little fuzzy. I can email more pix to someone who is seriously interested.
Last edited:
