Remington 700 308 scratching brass case

Discussion in 'Member Introductions' started by Vamike9, Aug 19, 2015.

  1. Vamike9

    Vamike9 Well-Known Member

    Messages:
    519
    Joined:
    Aug 19, 2015
    I have a Remington 700 that when feeding from the magazine scratches the brass cases and bullet. The feed ramp looks okay but not sure what else could be causing this. It is a brand new rifle shot less than 200 rounds. If I do not load the rounds in the magazine then it functions fine without damaging the cases. These are not light scratches but fairly deep. Any help with this would be greatly appreciated. If it is the feed lips what's the best way to go about polishing them or sending them, are there any videos out there showing this?
     
  2. engineer40

    engineer40 Well-Known Member

    Messages:
    903
    Joined:
    May 5, 2015
    Hey Vamike9. I don't think you'll get many responses asking your question in this area of the forum. But try posting it in the Gunsmithing area. People are very helpful there.
     
  3. Vamike9

    Vamike9 Well-Known Member

    Messages:
    519
    Joined:
    Aug 19, 2015
    Thanks I appreciate that information.