Rail bedded rings and scope setup question

[excaliber]

I have the 20 moa base bedded and installed. My question is the front ring and the way it has to sit on the base. This Zeiss V4 has a really short tube and the ring has to sit off the meat of the base a bit. It's 3/4 on the thickest part of the base.

I can't make any other adjustments as the ocular will hit the back of the base or the bell of the objective will not sit down in the rings if I move the ring forward.

Is there a problem with the ring being mounted on the rail like this? If so I'm out of options with this scope.

 

[L.Sherm]

I dont see any problem at all, this is the beauty of a 1 piece rail.

 

[sp6x6]

Yes as Sherm said .And if you really needed some wiggle room you could chamfer either end for clearance on top of rail

 

[excaliber]

Thanks guys. It's all mounted up and ready for the range.

 

[sedancowboy]

You are good to go like someone above said that is why we use rails.