Neck wall thickness of Remington 300 WSM Brass

358sta

Well-Known Member
Joined
Aug 21, 2006
Messages
187
Location
Longmont, CO
Can anyone tell me what the case neck thickness is on Remington 300 WSM brass?

I am ordering both the brass and dies at the same time and don't have any to measure myself.

I need the thickness to determine bushing size. I'm ordering Redding Type-S Neck Bushing Die set for my new Tikka T-3 in 300 WSM.

Thanks,
Kevin
 
Just checked a handful out of the only batch I have purchased. Straight out of the back, the thickness of these is .015-.016".

Hope this helps.
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top