Kimber Police Tactical Groups

tjbill

Well-Known Member
Joined
Jan 22, 2006
Messages
160
Location
Skagit Valley WASHINGTON
I tried out a load in my new Kimber Police Tactical in .300 Win mag on Sunday. I did some barrel break-in a couple of weeks ago and shot some factory ammo and a couple of handloads my buddy nwdan had around about a week ago and was less than impressed as the groups were all 1 - 1.5 inches. For Sunday I loaded up some rounds with RL 22 and 200 Grain Accubonds in .3 grain increments from 71.5 - 73.0 grains and the results are as follows. All are 3 shot groups measured center to center at 100 yards off the tailgate of my Toyota and sandbags with some gusty wind mostly from 6 o'clock.

71.5 gr 0.964" with two through the same hole
71.8 gr 1.038"
72.1 gr 0.176" pictured below
72.4 gr 0.212" pictured below
72.7 gr 1.205"
73.0 gr 0.877"

DSCN0109.jpg


DSCN0111.jpg


I think I found the sweet spot! Hopefully we can get out and chronograph it in the next week or so.
 
I think you should go with the 72.7 group. More of a shotgun effect!:D Just kidding, nice groupings. I always wondered how the Kimber police shot. Now I know!

Tank
 
Thanks for the comments! Just an off the shelf Kimber Police Tactical in 300 Win Mag, NF 5.5-22X56 in NF rings and 20 MOA base. The only thing I did was pull it apart, adjust the trigger down to about 2 lbs. and made sure everything was tight.

DSCN0133.jpg
 
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top