• If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here

Fireformed brass .025" to short?

gohring3006

Well-Known Member
Joined
Mar 17, 2014
Messages
4,556
Location
Ohio
I fireformed 22-250 Lapua brass to 6.5 Creedmoor, do you think that them being .025" to short will create problems like accelerated throat erosion, carbon ring or????
 
I fireformed 22-250 Lapua brass to 6.5 Creedmoor, do you think that them being .025" to short will create problems like accelerated throat erosion, carbon ring or????

when you fire form brass, it will almost always come out shorter. Just the nature of the beast. I do a 22-250 necked up to 6mm in an Ackley improved case. If I use 22-250 brass, I loose about .030", and then another .005" to square up the case mouth. Now I do all mine off of .243 Winchester brass with the case length as long as the chamber will allow. Plus there's less brass movement with the .243 case verses the 250 Savage case. I've see brass shorten as much as .040" after fire forming, and just expect it. Plus most chamber neck lengths are longer than need be, so take advantage of it.
gary
 
I consider any chamber end clearance inside 10thou good. Outside of that, depending on various things, can lead to increased neck sooting, carbon ring buildup, climbing SD.
Do your best to clean carbon at the end of the chamber, and mind fired cases for shiny spots on case mouths(telling sign of a carbon ring).
 
I consider any chamber end clearance inside 10thou good. Outside of that, depending on various things, can lead to increased neck sooting, carbon ring buildup, climbing SD.
Do your best to clean carbon at the end of the chamber, and mind fired cases for shiny spots on case mouths(telling sign of a carbon ring).
Thanks Mike, the shiny spots on the case mouth is very good info.
 
I fireformed 22-250 Lapua brass to 6.5 Creedmoor, do you think that them being .025" to short will create problems like accelerated throat erosion, carbon ring or????

0.020" short is good enough, but if you want them to form .005" shorter than spec, then .025" will be fine.
 


Write your reply...
Warning! This thread is more than 8 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top