I like the K&M turner with carbide donut mandrel. cost is about $80 also buy his expanding mandrel to match the cutter ($15). Accurate to .00002 inch. (717) 292-3175. Ken Markle will ship with receipt in box so you just send money in when you get it.
use black and decker 3.6 volt power screw driver with versa pack batteries $20 and sinclair internatinal power screw driver case holder heads ($44 for 3 set for all calibers) for turning at 180 rpm. Makes slick clean wobble free cuts. www.sinclairintl.com
by holland neck micrometer for $65 from www.hollandguns.com
use fp10 or the imperial size wax ken will send you to lube necks.
must size necks first, then expand with matching mandrell. use old brass to practice.
YOu can find more expensive but none better or easier.
Good luck
BH
[ 02-27-2004: Message edited by: BountyHunter ]
use black and decker 3.6 volt power screw driver with versa pack batteries $20 and sinclair internatinal power screw driver case holder heads ($44 for 3 set for all calibers) for turning at 180 rpm. Makes slick clean wobble free cuts. www.sinclairintl.com
by holland neck micrometer for $65 from www.hollandguns.com
use fp10 or the imperial size wax ken will send you to lube necks.
must size necks first, then expand with matching mandrell. use old brass to practice.
YOu can find more expensive but none better or easier.
Good luck
BH
[ 02-27-2004: Message edited by: BountyHunter ]