Copyyepper a single stack will modify the issues with feeding and a AI, run them out of a box and they'll feed but generally roughly and not close to as smooth as a non Ai case
My new Brux on my old 700 seems to have a thing for the 90 Hammer. Need to do some more work with it to know for sure, but initial work is good.
Anyone from LRHF been using the 90's in their 25's?
I have a 9 twist Brux and am not looking for data for the heavies please...
Many thanks, Life's short, hunt hard!
What are you using for components?Shot the load again last night, didn't show too well. Think I'll play with seating length a bit mo.....
You may need a faster powderHorn brass, 9 1/2's, 54/H4350 seated just off the lands
speed=just under 3300
You shooting the 90 AH's?Copy that, seems strange though for a 25/06 to use one much faster. Which one's are you thinking? I was thinking of trying a slower powder actually. But, am more than open to suggestions.
Varget, RL16, H380, and W760/H414 would be what I would tryjust checked and that is correct
I can do so, don't thinkCopy that, seems strange though for a 25/06 to use one much faster. Which one's are you thinking? I was thinking of trying a slower powder actually. But, am more than open to suggestions.I started at 54.5 grs of h 4350and got 3450 fps with less case capacity with the 25-284 I think you need too step the charge up I hit pressure at 59.5 grs leaky primer easy bolt lift at at3816 fps then changed too rl19 that's a 25 in 1-8 twist barrel cci 200 primers 30 off lanndsI can do so, don't think they'll get the speed of the slower powders though.I can do so, don't think they'll get the speed of the slower powders though.