7mm 08 using redding type s matching dies

[rockwallraider]

does .313 seem right for the bushing

 

[jimbires]

you're in the ball park . the easiest way I know to get started choosing a bushing is to measure a loaded round , and get a bushing .002" smaller than that . if your loaded round measures .315 then yes a .313 would be a good starting point .

 

[rockwallraider]

Thank you. That's what i did.

 

[jebel]

I'm using Lapua 7-08 cases and I get about 0.002" bullet tension with a .310 bushing, so my case necks must be thicker than yours. But I agree with the methodology jimbires and the OP described.

 

[rockwallraider]

I'm using Lapua 7-08 cases and I get about 0.002" bullet tension with a .310 bushing, so my case necks must be thicker than yours. But I agree with the methodology jimbires and the OP described.

what bullet

 

[jebel]

what bullet

I'm currently shooting the 131 grain Hammer Hunter, though this bushing size isn't bullet-dependent.

 

[SteveBurton]

The bushing is not bullet dependent. It is dependent upon brass manufacturer and whether you turn the necks or not. Looks like you have it figured out.

 

[rockwallraider]

ok thanks