JMHNL
Well-Known Member
- Joined
- Apr 6, 2015
- Messages
- 232
Just took delivery of 200pcs of ADG brass. I'm stoked, it's super nice and seems to have tight tolerances as advertised and talked about.
I just put together an Anti-X with a 24" Proof barrel. Been breaking in the barrel with some Nosler brass, RL26 and 156 EOLs with sort of underwhelming results in accuracy. I know that it is still not even broken in with 84 rounds down the tube....
So, the question is to all the gurus: where do I start? Ladder test? Regular OCW and then adjust seating depth? I also am not sure if I should resize this stuff before I shoot it, seems lots of guys just shoot it to FF straight out of the box. The brass chambers in the rifle fine so it's tempting to just shoot it, especially considering that my rifle still needs to be shot for break in.
I have RL25, RL26, H1000 and H4831sc on hand, primers, and plan on shooting 140 VLD Bergers and perhaps 156 EOLs later.
Thanks in advance for some starting points and insight to the above.
I just put together an Anti-X with a 24" Proof barrel. Been breaking in the barrel with some Nosler brass, RL26 and 156 EOLs with sort of underwhelming results in accuracy. I know that it is still not even broken in with 84 rounds down the tube....
So, the question is to all the gurus: where do I start? Ladder test? Regular OCW and then adjust seating depth? I also am not sure if I should resize this stuff before I shoot it, seems lots of guys just shoot it to FF straight out of the box. The brass chambers in the rifle fine so it's tempting to just shoot it, especially considering that my rifle still needs to be shot for break in.
I have RL25, RL26, H1000 and H4831sc on hand, primers, and plan on shooting 140 VLD Bergers and perhaps 156 EOLs later.
Thanks in advance for some starting points and insight to the above.