208 A-Max load rec's for 300 RUM


Well-Known Member
Jun 26, 2009
Arkansas Delta
I am sure that this type of post has popped up before, but I suck when it comes to searching the forums for old posts. So, thanks in advance.

I am looking for load recommendations for my 300 Rum using the 208 Amax. I use Retumbo with good success for my 190 VLD's, but am having trouble info on the 208's.

Also, do the Amax's typically like to be jammed or jumped. I usually jam the VLD's and am not worried about mag length as I shoot this one as a single shot.

I have a 28 inch HV Krieger on the rifle with a 1-11 twist.

Thanks again,

Also, bought some Remington brass today and it is the absolute worst brass I have seen. 18 of the 50's flash holes were not even close to being centered. Sucks that there are only two commercially available manufactures for this stuff (that I know about).
Warning! This thread is more than 15 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts