Recent content by rinodods

Up top...

Thanks 1badmopar. Hope the scope serves you well.

Ok I'll go $225.

Light to medium barrels is what Stockade says. That said I had a varmint barrel action sitting here I just gave it a try with. Looks like it makes some contact about half way between the barrel nut and the end of the stock but is clear the rest of the length. May just have a high spot in the...

Have an unused Stockade Gun Stocks hunting sporter stock money saver (unfinished) for short action 4.4 spacing with bolt release in the trigger guard. Looks like it is labeled 13.5" LOP. Been in the closet for the last five years. Builds took other directions. Getting ready for an out of state...

SPF to 1badmopar.

Lightly used NXS 5.5-22x56 with zero stops. No known ring marks or scratches. Haven't pulled rings or level to check. Still have everything that came with the scope right down to the Nightforce stickers and CD. Includes the bubble level and Nightforce 30mm Low Steel Ring Set - .885...

Check out this little diagram. https://www.smokingmeatforums.com/media/pid-image-2-jpg.213044/ That is basically how they get wired. Connections on the PID might vary slightly by brand

You are spot on. I've built a couple of these. Amazon also has prebuilt temp controllers that should fit the bill. Just make sure you can find a probe for the proper conditions and your temp range. I used something like (https://www.amazon.com/dp/B01N31E8BN/?tag=lrhmag19-20) for my last build...

I think I have a pretty complete list with links to what I got for parts. With any luck I can dig up a schematic. There are plenty of them online for building these. It isn't very expensive either. Let me dig a little and I'll get back to you.

Been doing this for a while and love it. Gotta get a fixture from him. Mine was a quick setup to run it for some testing. I also built a temp controller (PID) for mine though. Probe goes through the fixture you plug the pot into the controller with it turned on then set the temp you want on the...

I heard they were quick. I pulled an HST off another rifle for now since I'm gonna be attempting an elk hunt in a few weeks. No time to really send for RMA, wait and get everything with the rifle finished out. Had zero issues with the HST on the same rifle with the same mounts. I know they'll...

So out shooting some new loads in 300wm today on a rifle I've shot a few times and had zeroed last trip. First shot with same load as last time out goes 4" high but center. Every other shot after that goes 6" left and 2" low. At first I thought the magnetospeed bayo was really playing with me...

You know what let's call it $150 for either and I'll quote you shipping if you send me your zip. So that's $150 and shipping is on you. They aren't doing anyone any good collecting dust on my shelf. gun)

I believe these were actually made as .25" IPHY.