Fire (heat) cracking.

ptb

Well-Known Member
Joined
Sep 17, 2017
Messages
105
Ran a scope thru my 6.5 creed and found more heat cracking (checking) than I would have thought with 500 rounds or so. How much is too much. Accuracy becoming inconsistent. Use Reloder 17. Thx, pete
 

Attachments

  • C153931D-F699-4E71-BD93-92FA2343FB5C.jpeg
    C153931D-F699-4E71-BD93-92FA2343FB5C.jpeg
    1.6 MB · Views: 202
Would a " more expensive" bore scope given me a different look or opinion about that damage?????

Yes it's right at the lead edge of the throat. Thx for your input. Also found some pitting further down the barrel.

yea, also noticed the start of a carbon ring. Need to get after that too!
 
Here is more damage.
 

Attachments

  • 278C0F65-ACF4-4B33-94B6-218E82FD6FB7.jpeg
    278C0F65-ACF4-4B33-94B6-218E82FD6FB7.jpeg
    31.5 KB · Views: 172
Here is more damage.
I've saw pits like that on brand new unfired barrels. I'm not saying that it's not a problem I'm just saying it could have been there early on unless you bore scoped it new and saw it. The edge of the rifling with the chunk out is more worriesome. Have you been chasing your rifling with running your seating depth out? Or just kept seating depth the same after you found your load?
 
If you're losing accuracy at 500 rounds in a 6.5CM, barrel wear is unlikely to be your issue. You've got a carbon ring or some other issue unless you sat there and fired those rounds until the barrel was red hot...and then just kept going. I've got 1000+ rounds on both a 300WM and a 243 AI only starting to marginally increase groups. This is not an exception but rather typical.
 
I am sorry if I came off like an A hole. Kind of wishing I didn't buy one!!! Lol. Agree that too much info not always the best!
 
It's one of those ignorance is bliss things. That is nothing, don't worry about it, and sell your bore scope to somebody you don't like so they can obsess about nothing.

The worst thing you can do is start questioning your rifle because you opened Pandora's box and can't go back. It's physics and it is in every rifle that has been fired. Don't look again until the rifle has 2000 rounds or you start crushing shoulders and blowing primers. It's like changing your oil every 500 miles because it isn't clear anymore.

The second worst is going after it and aggressively scrubbing the barrel or, more specifically, the throat. That will ruin it for sure.
 
Warning! This thread is more than 5 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top