Tikka COAL and Lower Metal Adjustments

[jbenevides89]

No I left those alone. Just the front lip a little because it was too tight to get it to release. Ill get a pic of it tomorrow.

 

[NorCalAOSHunter]

No I left those alone. Just the front lip a little because it was too tight to get it to release. Ill get a pic of it tomorrow.

I appreciate it

 

[jbenevides89]

 

[NorCalAOSHunter]

A competent gunsmith trimmed a bit off the ramp and polished it. Roughly .10

@grouse
Any chance you could shoot me a pic of the end result? Want to compare with mine as it exists stock

 

[NorCalAOSHunter]

Maybe its a different Mag? I am using the metal Accurate Mags. It could just be the bottom metal difference allowing mine to set back a hundredth or two more. I had to trim the front lip of my mag to get it to seat well but thats about it.

After a lot of tinkering, I think it is likely the BM difference that allows the 3.570 in the Atlasworks vice the MT. I am still getting the tip hitting at 3.550, I think I will need to do the action mod.