Scope Rings

[Wedgy]

Audere is very similar the Spuhr but less expensive if you are going with the stronger 1 piece design.
http://darnfineshot.com/noname2.html

 

[Rob01]

Have used Seekins since 2005 and never let me down on my match rifles. They hold the Gen III 6-36 just fine on my rifle as they did my other optics like the Gen II below. When the Gen III comes in for this rifle it will be going in them.

 

[Outlaw6.0]

Have used Seekins since 2005 and never let me down on my match rifles. They hold the Gen III 6-36 just fine on my rifle as they did my other optics like the Gen II below. When the Gen III comes in for this rifle it will be going in them.

Truth be told, both of my XTRIIIs are sitting in Seekins rings.... I was being a tightwad after dropping $3k in optics at the same time (just before they went on sale of course).

Are you the same Rob01 from Sniper's Hide?




t

 

[Rob01]

Are you the same Rob01 from Sniper's Hide?




t

That depends. Did I ban you there? LOL Yes same one.

 

[Outlaw6.0]

That depends. Did I ban you there? LOL Yes same one.

No sir. Just recognized the screen name.



t

 

[COmtnman1]

I'll third the Farrell rings & bases, superb quality & customer service!!

https://www.kenfarrell.com

 

[vmaxmike]

My vote is TPS they guarantee a .0002 tolerance and offer lots of choices in heights and design.

https://www.tpsproducts.com/

M.

 

[Taylorbok]

I just picked up an MDT mount it's solid definitely recommend them, or the Near mount.

 

[wasskeet]

I took @lancetkenyon advice and ordered some Seekins for a new setup. Haven't got them put on yet, but they appear to be very well made and priced decently.

 

[Sending156s]

Len, if weight doesn't matter I use the Hawkins Heavy Tactical 2 piece. I'm running a 1.15 35mm on a 7x35-56 Mark5HD, 20 MOA Impact, M24 profile & have 1/8 to 1/4 clearance between scope cap & barrel. The 34' s are easier to find. Good luck!