Rem700 eject issue

[remly]

Recently sighted in a never fired 10 year old Rem700 LTR 20" .308. I used 147gr ball loaded in Armscor new brass. Immediately had issue ejecting fired cases. They came out but with effort. When I switched to my premium federal 150gr ballistic tips all rounds ejected smoothly. This rifle shoots 1/2MOA. Question…..Is it the Armscor brass or the pressure of the load causing those cases to stick? My guess these 147gr loads were meant for a gas operated semi auto rather than a bolt action in an barrel not fully broken in yet. Appreciate some insight.

 

[sedancowboy]

I would say like most Remingtons that the primary extraction is off and needs to be timed correctly.
There are threads about this here. There is someone who fixes them but I don't have that info readily at hand.

 

[remly]

I thought it may be the bolt and switched it out with 2 other rem700 without incident. Tried this bolt in the other 2 rifles with the 147gr without incident. Left me thinking a tight chamber that was finicky about the
armscor 147gr.

 

[remly]

No incident with federal and Nosler factory loads.

 

[Taylorbok]

I'm assuming you mean extraction issue. Lots of Rem's have junk primary extraction, Take to your smith and he should be able to sort it out for you